Fault Codes - King Tony 9DS31 Mode D'emploi

FAULT CODES

1. No clamps connected
F1 2. Short circuit
3. Reverse polarity connection
F2 Loose clamps during charging
F3 Battery voltage is too high
F4 Bad Battery
MAINTENANCE
• After each use, clean the battery charger clamps be sure
to remove any battery fluid that will cause corrosion of the
copper clamps. Clean the outside case of the charger with a
soft cloth and, if necessary, mild soap solution.
• Keep the charger cords loosely coiled during storage to
prevent damage to the cords.
• Do not use the charger if cords or clamps have been
damaged in any way.
• If the power supply cord is damaged, it must be replaced
by the manufacturer, its service agent or qualified person in
order to avoid a hazard.
EN
FR
ES
5