E-7000Tb Terminal Board Wiring - Toa N-8400RS Manuel D'installation

Step 4. Insert the wired terminal plug into the terminal block of the N-8400RS.

6.5. e-7000Tb Terminal board Wiring

For cable connection to the E-7000TB Terminal Board, use the optional YC-105 Clipping tool.
Hook the end of the cable onto the terminal and, with the cable end in hand, press the YC-105 down onto the
terminal from above. Pressing down the YC-105 tool cuts off the excess cable end, securing the connection.
For cables, refer to p. 13, "Type of Cable."
Yellow
Cable
Hook the cable onto
the terminal without
stripping the cable
sheath.
14
Tighten
3
4
2
Removable terminal plug
(accessory)
Clipping tool YC-105
Gray
Cut end
Terminal
N-8400RS rear panel
Removable terminal block
(Optional)
Terminal board E-7000TB
Bind the cables using the cord
clamps supplied with the E-7000TB.