Connection Of A Matching Endoscope Camera; Switching The Device On/Off - VOLTCRAFT BS-1000T Notice D'emploi

d) Connection of a Matching Endoscope Camera
For a matching endoscope camera, see
the chapter on matching accessories.
e) Switching the Device On/Off
Keep the button
After the start-up-screen, the battery charging state and the SD card capacity is briefly displayed on the
screen.
Charge the endoscope when the battery level is low.
A camera live image is displayed on the screen.
The endoscope is now in preview mode.
pressed for 3 seconds to switch the endoscope on or off.
1. Connect a compatible camera to the socket.
Observe correct alignment; the hollow part on
the plug (at the endoscope camera) should fit
over the protruding part on the socket (basic
device). Make sure not to break off the pins.
2. Turn the metal screw lock clockwise to fasten
the camera.
3. Loosen the camera by turning the metal lock
counter-clockwise.
31