Placement Of Separate Components - HWAM 3310 Manuel D'utilisation

Distance to inflammable material, drawing A
Your HWAM stove must always be installed on a fire-proof surface. If installed on a wooden floor or
similar surface, the floor must be covered by a fire-proof material.
Note: HWAM 3310 and HWAM 3320 must always be mounted on the wall or on a plinth.
Min. distances:
1. To brick wall at the rear
1. To inflammable wall at the rear
2. To brick wall at the side
2. To inflammable wall at the side
3. To brick wall at the side, corner installation
3. To inflammable wall at the side, corner installation
4. Distance to furniture in front
For wall-mounting, the stove must be placed at least 24 cm above any inflammable flooring. This also
applies to any floorboard placed on the floor.
Please be aware that not all glass parts are heat-resistant. For this reason, a glass wall should sometimes
be treated as a flammable wall, in which case we ask you to contact your local chimney sweep or glass
producer to hear at what distance the stove should be kept from glass.Remember to pay attention
to any regulations concerning the required distance between the wall and smoke pipe.
*The distance to a brick wall is set to faciliate the servicing of the automatics system.
The HWAM 3310/3320 with wall fittings can be mounted on a brick wall; however, this means that
the stove must be taken down when the automatics system is to be serviced.
Requirements for chimney and smoke pipe
The chimney must be tall enough to provide a proper draught and prevent smoke problems.
The stove requires a draft of at least 12 Pa
The chimney must have a minimum internal diameter of Ø150 mm.
However, the chimney's minimum internal diameter must match the stove's outlet socket.
The chimney must be equipped with an easily accessible soot door.
Smoke pipe and chimney must always be suitable for a stove connection. Ask your HWAM dealer
for more information.
P
lacement of seParate comPonents
Before using the stove, please ensure that all separate components are correctly placed, cf. drawing B.
1. The smoke shelf must rest on the rear plate and on the slanted side panels.
2. The baffle plate must be secured with hooks at the top of the stove and slant backwards.
To access the baffle plate, you need to remove the smoke shelf, cf. the maintenance section.
3. The removable rear plate which covers the automatic system must always be installed.
4. Cover plate over shaking grate. Used to ensure extra long burning time.
Mounting the stove on a plinth, drawing D
Mount the plinth with the open side facing forwards at the location where the stove is to be placed.
Place the stove on top of the plinth so that the 2 guide pins (1) on top of the plinth fit into the 2
holes (2) in the bottom of the stove, and the guide block (3) fits into the hole (4) at the bottom rear
edge of the stove.
10 cm*
15 cm
10 cm
25 cm
10 cm
15 cm
80 cm
49