HAEGER Ash Fire 18 Mode D'emploi page 8

English
Maintenance & Filter Cleaning
WARNING:
– Always remove the plug before cleaning.
– Under no circumstances should you immerse the power head lid in water in
order to clean it. Otherwise this might result in an electric shock or fire.
CAUTION:
– Do not use a wire brush or any abrasive items.
– Do not use any acidic or abrasive detergents.
Removing and cleaning the filter
1. Verify that the power cord is disconnected from the outlet.
2. Release both metal clamps and take off the top cover.
3. Disconnect the flexible hose turning clockwise and pull.
4. Gently shake out the ashes from the hose and canister in a suitable
dustbin.
5. Clean the canister with a humid towel, and then wipe it dry with a
clean towel. Do not use cleaning agents.
6. Turn the metal mesh cover counter-clockwise to detach it from the top
cover.
7. Gently shake out the ashes from the metal mesh cover in a suitable
dustbin.
8. Rinse the metal cover with fresh water, and then wipe it dry with a
clean towel.
9. Pull the filter carefully off the top cover.
10. Gently shake out the ashes from the filter in a suitable dustbin.
11. Use a soft paintbrush to clean the outside of the filter. Rinse the inside of
the filter with cool water using a gentle stream, and then let it air-dry at
room temperature.
Caution:
o Do not use warm or hot water to clean the filter. Do not use cleaning
agents, hard brushes, or any other sharp instruments.
o Do not use any heating devices (such as hair dryers) to dry the filter.
Leave it to dry in the air.
6 Instructions for use