Safety 1st Glow & Go Mode D'emploi page 5

Setting Up Your Glow & Go Monitoring System
Choose Locations:
IMPORTANT: When choosing locations to set
up the Baby's Unit and Parent's Unit follow
these guidelines:
• For best sound quality, place Baby's Unit 4
to 6' (1.5 to 2 m) away from the baby.
• Use the Parent's Unit far enough away
from the Baby's Unit so as not to get
feedback.
To Set Up the Parent's Unit:
CAUTION
• When using batteries, check batteries regularly. DO NOT use monitor system in
portable mode when batteries are low.
• DO NOT submerge any part of the product in water.
• Remove batteries when stored for long periods of non-use.
• Unplug power cord before replacing batteries.
NOTE: The Parent's Unit and Baby's Unit may use either the
AC adapter or batteries. When plugged in, the AC adapter will
be the source of power.
1. Battery Use: Unscrew the screw on the back of the
Parent's Unit (Figure A). Pull off the battery door.
Insert batteries with polarity as indicated. Secure the
door with the screw.
2. AC Use: Connect the AC adapter into the side of
the Parent's Unit (Figure A). Connect the AC
adapter into a power outlet.
NOTE: Parent's Unit may be used as traditional monitor,
on a table top or other flat surface, or it may be carried
with you. If desired, slide the belt clip over your belt.
BATTERY CAUTION:
• Keep these instructions as they contain important
information.
• DO NOT mix old and new batteries.
• DO NOT mix alkaline, standard (carbon zinc), or
rechargeable (nickel-cadmium) batteries.
• Non rechargeable batteries are not to be recharged.
• Check that all contact surfaces are clean and
bright before installing batteries.
• The supply terminals are not to be short-circuited.
• DO NOT submerge any part of the product in water.
• Dispose of batteries safely.
• Remove batteries when stored for long periods of
non-use.
• Unplug power cord before replacing batteries.
All manuals and user guides at all-guides.com
• During use of the monitor, if the sound
quality deteriorates you may be reaching
the limits of the monitor's range. If this
happens, you will need to move the
Parent's Unit in closer proximity to the
Baby's Unit.
• Adjust the volume to a comfortable level
for your environment.
A
• Use only the adapters supplied with this
product. Incorrect adapter polarity or voltage
can seriously damage the product.
• THERE IS A RISK OF EXPLOSION IF THE
BATTERIES ARE REPLACED BY AN
INCORRECT TYPE.
• Use AAA size alkaline batteries only for parent
unit, and a 9 volt battery for baby's unit
(batteries not provided).
Screw
5