Transport And Storage - Dri-Eaz Velo Guide D'utilisation

or servicing your equipment and to contact you in case we have
important safety information concerning your Dri-Eaz product. If
you determine service is required, have your equipment model,
serial number and original proof of purchase available and call
your distributor for assistance with obtaining a return material
authorization (RMA).
OPERATING INSTRUCTIONS
Note that the Velo can be placed in a variety of positions for
drying and air circulation. See Fig. B for details.
1. Unwrap the cord and plug the unit into a standard 115V
GFCI-protected outlet. CAUTION: Be sure switch is in the
off position before connecting unit to power outlet.
2. Direct the Velo outlet toward the surface to be dried.
TIP: On the Velo Pro (F505), the airflow may be adjusted by
pressing the Up or Down arrow on the speed control (Fig. D). A
digital readout shows the approximate amp draw. Use this value
to maximize the number of Velos you can place on a single
circuit.
3. When surface is dry to the touch, switch the unit off and
reposition the unit in the next area to be dried.
4. When finished, unplug the unit and re-wrap the cord in the
cord wrap.
For additional instructions about the use of airmovers for
restorative drying, visit www.DriEaz.com
www.RestorationSciencesAcademy.com.
Electrical safety devices
Circuit breaker: If the circuit breaker detects overload or short
circuit conditions, the breaker will automatically shut off the
electrical supply. If this should occur, check the power cable
carefully for any damage and ensure it is plugged into a properly
grounded outlet. Press the "Circuit Breaker Reset Switch (Fig. A)
to reestablish the electrical supply.
Ground Fault Circuit Interrupter: If the GFCI device detects a
ground fault, it will automatically shut off the electrical supply. If
this should occur, check the power cable carefully for damage
and ensure it is plugged into a properly grounded outlet. Press
the GFCI reset button (Fig. A) to reestablish the electrical supply.

TRANSPORT AND STORAGE

Always use the handle to load or carry the unit.
Wrap cord in a counter-clockwise direction under front Cord
Wrap tab and rear bottom edge (Fig. A). Pull cord snug and
secure with plug clip.
Units may be stacked for transport and storage.
When transporting in a vehicle, secure the unit(s) carefully to
prevent sliding and damage to the unit and/or injury to vehicle
occupants.
Keep unit dry. Do not expose the unit to rain or snow.
07-01837D F504/F505-115V
and
2
Fig. C: Disassembly
To disassemble for
cleaning, first remove the
four screws from the
impeller assembly 1)
(below), then turn the unit
on its top and 2) remove
the six screws from the
base. Lift off the housing.
Retain screws and
washers for reassembly.
1. Remove impeller
assembly screws (×4).
Fig. D: Pro model: Variable speed control
with amp and total unit hours display
Maintenance
WARNING: Unplug unit before performing any maintenance.
Before each use
Inspect the power cord. If cord is damaged, do not use. Always
grasp the plug (not the cord) to unplug.
As needed
Clean housing and impeller. If dust accumulation is visible,
remove the four screws from the top, then turn the unit on its top
and remove the six fasteners from the bottom as shown (Fig. C).
Lift off the housing. Clean impeller assembly with pressurized air
and/or with a soft cloth. Do not apply liquids to the impeller
assembly. The housing may be cleaned with a mild solution of
detergent and warm water. Ensure housing is completely dry
before reassembling.
2. Remove base
screws (×6) and
lift out housing.
Dri-Eaz Products, Inc.