Hub800, As6W, Rps10; Hub800; As6W; Rps10 - dB Technologies RS16000TR Caractéristiques Techniques

English English

5. HUB800, AS6W, RPS10

This paragraph features technical information on some components of RS16000TR.

HUB800

HUB800 is the interface that allows controlling over the network the 6 receivers of RS16000TR
via a PC.
The connection is carried out through the front (USB) or rear (ETHERNET) port shown in the
figure.
The 3 UP, DOWN and ESC keys and the Select-Push knob on the front side allow local control.
The configuration parameters are shown on display.
For a correct operation all receivers must be set to the same Country and Bank.
In the main page of the display, among the other indications:
• at the top left side an indicator shows the type of connection (to network, to PC, to PC
through Network)
• the boxes in the middle and on the right side show the indicators of the transmitters, if
associated, the battery levels, the channel used and the intensity of the signal received by
the receiver.

AS6W

AS6W is a splitter antenna, with 2 inputs with BNC connector and typical 3dB gain. The input impedance is 50
ohm, as the output one. The Phantom Power supplies 9V power and its turning on is signalled by the relevant
front LED.

RPS10

RPS10, besides systematically supplying the various sections of RS16000TR:
• guarantees protection against overcurrents on each single power supply line
• activates in case of short circuits by disabling the line and signalling the user the problem, with the relevant
LED flashing once every second
RS16000TR
IT
Ch01
Bank 01
Ch03
Ch05
Cod. 420120285 REV. 1.0
Ch02
Ch04
Ch06
37