WARRIOR Rampage Manuel De L'utilisateur page 11

snowplow asseMbly
8. Attach the T-shaped receiver tongue to the A frame using the two frame pins (7,
fig.12). Lock the pins into the A frame with an M8 x 52 mm gr.8 hex head bolt
inserted through the top of the frame at each end (42, fig.12) and secured with 8
mm washers and M8 Nylock nuts.
9. Bolt the winch support tower to the top of the receiver tongue "T" using 4 M10
x 75 mm hex head bolts (32, fig.12), washers and nuts (through the base of the
winch support and the cross-bar of the "T") and 1 M12 x 75 gr.8 hex head bolt
(57, fig.12) and nut (through the base of the winch support and what would be
the vertical leg of the "T").
10. If not already attached, bolt the winch to the head of the winch support with 4
M8 x 30 mm gr.8 hex head bolts, 8 mm
washers, and M8 Nylock nuts (47, fig.13),
the bolts being inserted from the front,
through the winch base then the winch
support and the washers and nuts threaded
on from the back of the winch support.
11. Remove the gr.8 U-bolt from the top of the
A frame, attach the lower end of the winch
strap to it and re-attach. The strap should
feed over top of the barrel of the winch
toward the front and down to the attachment
point on the A frame.(fig.13). The U-bolt
should not be tightened fully. It should have
a little play.
12. Align the D frame's 3 attachment points with
the two vertical centre ribs of each plow
blade panel as well as the double, joined
vertical ribs in the middle of the plow (fig.14). Insert clevis pins through each
attachment point and the vertical ribs on the back of the blade. Secure the
clevis pins (23, fig.15) in place with cotter pins and bend them so they remain in
place.
13. If not already done, attach the 2 fixed castors to the castor holder shafts
(14, fig.15) and slide them from below into the D frame's shaft holders. Lock
them with the castor adjustment pin at such a height that the D frame is lifted to
horizontal and the blade vertical.
14. If not already done, attach the swivel castor to the remaining castor holder
shaft and slide it from below into the shaft holder in the A frame. Lock it with the
castor adjustment pin so that the frame is horizontal and the blade vertical.
15. Hook the trip springs (18, fig.15) into the holes in the top cross rib at the back of
each plow blade panel (37/38h, fig.15). Attach the springs to the angle plates on
the D frame (5a, fig.15) using for each an M12 gr.8 eyebolt (17, fig.15), M12 nut,
2 12 mm washers and an M12 Nylock nut.
16. Tighten the Nylock nuts to the point where the springs are just tight. Then turn
the Nylock nut, shortening the take-up by 6 mm (1/4 inch) further so the springs
open slightly. Snug up the inner M12 nut to hold the assembly tight.
En.11
v.121006