D-To Reset The Factory Default; E- Indications - SCS Sentinel CodeAccess Mode D'emploi

To gate automation
D- TO RESET TO FACTORY DEFAULT D- TO RESET TO FACTORY DEFAULT
a. Disconnect power from the unit
b. Press and hold # key whilst powering the unit back up
c. On hearing two "Di" release # key, system is now back factory settings
Please note only installer data is restored, user data will not be affected.

E- INDICATIONS

E- INDICATIONS
Operation Status
Open the door
Stand by
Press keypad
Operation successful
Operation failed
Enter into programming mode
In the programming mode
Exit from the programming mode
Red Light Green Light
Bright
Bright
Bright
Bright
Bright
POWER 12V DC
Yellow Light Buzzer
DI
DI
DI
DI DI DI
Bright DI
DI
en
13