Yardistry CS008 Serie Instructions

Yardistry Structures- Collection Series CS008
Fig. 1
2. Cut Posts and Rails to size indicated. (Fig. 2)
Circles and Triangles indicate at 45° cut.
Mitre Box or Mitre Saw)
3. Where indicated by a triangle, use a 1/8" drill bit
to pre-drill a hole into the center of the 2x2 Rail.
(Fig.3)
4. Attach Post and Rails to panels with 2 1/4"
screws in locations indicated by circles using
pre-drilled holes where available. (Fig.4) When
pre-drilled holes are not available use a 1/8"
drill bit to drill holes on an angle in the inside of
the panel as shown. (Fig. 5)
Fig. 4
Screw on Backside
1. Assemble panel in configuration shown.
(Fig. 1) Secure with 2 1/4" screws provided
in the direction and location of the arrows.
Use pre-drilled holes when available.
*Ensure Panels are oriented correctly!
(Fig. 1A)
(Use a
2' 7 1/2"
(80.0cm)
Screw on Backside
Center the
Panels on
Posts and
5. Using a 1/8" drill bit, pre-drill Post and Rails in locations indicated by
Rails before
attaching!
the arrows and attach to side posts using 2 3/4" screws. (Fig.4)
*If you purchased the Post Stake to secure your project, please refer to the
instructions provided with the post stake to anchor your project to the ground.
(2.54cm)
1/8" Drill
Hole
Fig. 3- Pre-Drill Hole with 1/8" Drill Bit.
2 x One High X Topper | 2 x Arch Topper
2x -2"x2"x62" Post/Rail
YM11528
B.
Pilot holes to the right
Fig. 1A - Filler Strips on Bottom
of Panel!
8 11/16"
(22.1cm)
Fig. 2
Insert male into female. Slide down until fl
adjacent panel.
Introduzca el extremo macho en el extrem
(49.5cm)
Deslícelo hacia abajo hasta que quede a
panel adyacente.
Insérez les pièces de raccordement mâle
pièces de raccordement femelles. Faites
panneau vers le bas jusqu'à ce qu'il soit a
niveau que le panneau adjacent.
Cut Rail
Assemble Panels side by side. (Maximum
Conecte los paneles lado a lado.
Assemblez les panneaux côte à côte.
Finished Project
8 11/16"
(22.1cm)
(111.8cm)
(49.5cm)
Groove
Thick Piece
of Wood
Fig. 5
2 1/4" Screw
Drill Hole on an Angle
Remove the male connectors from the ou
Top View - Note:
Circles and
Triangles indicate a
45° cut.
2' 7 1/2"
(80.0cm)
Skinny Piece
of Wood