Publicité
Les langues disponibles
Les langues disponibles
Storage of gas cylinders
Store the gas cylinder in a cool, dry and ventilated area, protected from sunlight and do
not exposed to temperatures above 50 .
Connection of the refrigerator to the cylinder of liquefied petroleum gas
A
B
B
CAUTION: always stay clear of any source ignition during this operation. Do not smoke.
Connect the COOLBOX in the following order:
Gas cylinder > pressure regulator > appliance
Be sure that the A & B connections are tighten very well, check this regularly, manually is
not good enough. When you change the gas bottle it is possible that B is not tight
enough.
If you wish to check for leaks, please use soapy water, do not use a flame.
It is prohibited to check for leaks with a flame.
Do not smoke: danger of explosion and burns.
When changing the gas cylinder and/or disconnecting the hose, it is mandatory to close
the valve of the gas cylinder.
Replace the hose if it is damaged or if it becomes porous and in any case before the
expiry date printed on the side.
Gas valve assembly
This assembly consists of an adjusting device with an incorporated safety pilot, a burner
with an electric igniter.
The adjusting device can be set to 3 different positions:
Max
Maximum cooling
MIN
Minimum cooling
0 off
Igniting position / burner gas supply closed
The safety pilot automatically maintains the gas supply to the burner, as long as it
remains lit. It automatically shuts off the supply if the flame goes out.
Ignition of the liquefied petroleum gas burner
Open the valve of the gas cylinder.
Press the adjusting knob and hold it in this position, then turn the knob anti-clockwise to
Max.
If the appliance has not been ignited for a long period, or if the gas cylinder has been
changed, there may be some air in the duct, so it may fail to be ignited. It is necessary to
check that the pilot is lit by looking through the orifice at the top of the appliance. If the
appliance fails to be ignited, try it again after approximate 10 seconds.
When the outside temperature is low, set the adjusting device to MIN after a sufficient
long cool-down period in MAX position.
To disconnect an appliance running on gas Far from any source of ignition
Shut off the gas cylinder or the pressure regulator.
Turn the knob to the OFF position.
Storing food
Liquids to be stored in the refrigerator shall always be placed in a closed vessel.
The air circulation inside the appliance must not be obstructed.
Never place hot food or drink in the appliance.
Never keep flammable liquids and/or gases inside the refrigerator. Danger of
explosion.
Defrosting – Measures to be taken if the appliance is to be left unused for a long
period
The refrigerator must be defrosted regularly, in order to ensure that it operates
correctly.
To defrost the refrigerator, disconnect it and remove all food outside. If necessary, use a
cloth soaked with hot water. After de-icing, mop up the water with a dry clean cloth and
clean the inside.
If the appliance is to remain unused for a extensive period, disconnect it and remove all
food outside. After de-icing, clean and dry the inside of the appliance.
In order to prevent unpleasant odor, leave the cover of the refrigerator slightly open.
Publicité
