Thermador Star Sapphire Serie Manuel D'utilisation page 34

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fault
A different error code is indi-
cated on the digital display.
(
:
to
:
)
"
‹‚
"
„‹
Refill indicator for salt
P
and/or rinse-aid
is lit.
H
Refill indicator for salt
P
and/or rinse-aid
is not lit.
H
Water is left in the appliance
at the end of the wash cycle.
Dishes not dry.
Plastic dishes not dry.
Silverware not dry.
Appliance interior wet after
rinse cycle.
34
Cause
A technical fault has probably
occurred.
No rinse aid.
No salt.
Sensor does not detect salt tablets. Use different special salt.
Refill indicator switched off.
There is still enough special salt/
rinse aid available.
Filter system or area under the fil-
ters
is blocked.
1b
Wash cycle has not ended yet.
No or too little rinse aid in the dis-
penser.
Wash cycle selected without drying. Select wash cycle with drying.
Water collecting in depressions on
the dishes and silverware.
The combined detergent used has a
poor drying performance
extraDry to increase drying not acti-
vated.
Dishes were removed too early or
drying process had not ended yet.
The eco rinse aid used has a limited
drying performance.
Special properties of plastic.
Silverware not arranged properly in
the silverware basket.
Silverware not arranged properly in
the third rack.
No appliance fault.
Remedial action
Switch off appliances with the ON/OFF switch
. After a short time restart the appliance.
(
If the problem recurs, turn off the tap and pull
out the mains plug.
Call customer service and mention the error
code.
Refill rinse aid.
Refill with special salt.
Activation/deactivation.
Check refill indicator, levels.
Clean filters and area underneath.
Wait until wash cycle ends or reset.
Refill rinse aid.
Arrange dishes in a sloping position, arrange
affected dishes as sloping as possible.
Use different combination detergent with better
drying performance. Use of rinse aid also
increases the drying performance.
Activate extraDry.
Wait until wash cycle ends or wait until 30 min
after wash cycle ends before removing dishes.
Use a proprietary rinse aid. Eco products may
have limited effectiveness.
Plastic has a lower heat storage capacity and
therefore dries less well.
Separate silverware if possible, prevent con-
tact points.
Arrange silverware properly and separate if
possible.
On account of the "Condensation drying" prin-
ciple, water droplets are physically induced
and required in the container. The humidity in
the air condenses on the inner walls of the
dishwasher, drains and is pumped out.

Publicité

Chapitres

Table des Matières
loading

Table des Matières