Before Getting Started - Franklin Electric INLINE Serie Mode D'emploi

BEFORE GETTING STARTED

Read and follow safety instructions. Refer to product data plate(s) for additional operating instructions and specifications. This device is an
independently mounted operating control for use with water pumps that conform to the ratings listed in the specification table and comply
with type 1.C action.
This is the safety alert symbol. When you see this symbol
be alert to the potential for personal injury:
DANGER
warns about hazards that will cause serious personal injury, death, or major property damage if ignored.
WARNING
CAUTION
warns about hazards that will or can cause minor personal injury or major property damage if ignored.
NOTICE
indicates special instructions which are important, but not related to hazards. Carefully read and follow all safety
instructions in this manual and on pump.
WARNING
RISK OF ELECTRIC SHOCK - This product is supplied with a grounding terminals. To reduce the risk of electrical shock, be certain that
incoming power and pump ground conductors are connected to the proper grounding terminals. Disconnect power before working
on or around the product.
This equipment should be installed by technically qualified personnel. Failure to install it in compliance with national and local electrical
and plumbing codes and within Franklin Electric recommendations may result in electrical shock or fire hazard, unsatisfactory performance,
or equipment failure. Installation information is available through pump manufacturers and distributors, or directly from Franklin Electric
at our toll-free number 1-800-701-7894.
This equipment must not be used by children or persons with reduced physical, sensory or mental abilities, or lacking in experience
and expertise, unless supervised or instructed. Children may not use the equipment, nor may they play with the equipment or in the
immediate vicinity.
If the power cord is damaged, it must only be replaced by qualified personnel.
CAUTION
• Keep work area clean, well-lit, and uncluttered.
• Keep safety labels clean and in good condition.
• Wear safety glasses while installing or performing maintenance on pump.
• Do not run pump dry. Fill pump with water before starting or pump will be damaged.
• Make sure all ELECTRICAL POWER IS OFF before connecting any electrical wires. Follow all device wiring instructions
provided in the "Installation: Electrical Wiring" section of this manual.
warns about hazards that can cause serious personal injury, death, or major property damage if ignored.
W A R N I N G
on your pump or in this manual, look for one of the following signal words and
W A R N I N G