Husqvarna TANK PAD SET Mode D'emploi page 8

- Detach cover on the left and right side.
- Press in locking mechanism and remove cover upwards.
- Detach right fairing in area and remove.
- Detach left fairing in area and remove.
- Drill assembly holes using corresponding drill bit to 4.5 mm dia-
meter (pre-drill to 1 - 2 mm).
- Pull protective fi lm off the tank pads (included).
- Mount left tank pad on left side fairing.
Pins rest in the holes.
NOTE
The numbers are at the front in the direction of travel.
8