Control Location; General Operations - iDance Cube Nano CN2 Mode D'emploi

FEATURES
Bluetooth wireless stereo audio streaming
Support A2DP Profiles for most smart phones / laptops
Aux In input (3.5 mm Stereo Mini Jack)
Microphone input (3.5 mm Stereo Mini Jack)
Disco ball with Disco light effect
Micro USB jack for battery charging
Built-in lithium-ion re-chargeable battery

CONTROL LOCATION

1. DISCO BALL
For different color LED light show.
2. Mic-IN 3.5mm Jack
Connect 3.5mm mini jack to this port to sing or make voice announcement with CN2.
3. AUX In (Line Input / Audio Input) 3.5MM Input Jack
Connect a music device (MP3 player etc.) to this socket with a 3.5mm mini jack audio
cable to play through CN2.
4. Battery Charging indicator:
Insert micro USB cable to this port and connect to USB port for charging, the indicator
will turn red. The indicator will be light OFF after fully charged.
5. MICRO USB JACK
Connect the micro USB cable to charging the built-in battery.
6. Power, LED ON / OFF
Slide this switch to ON for turning on the CN2,
Slide to LED to turn CN2 ON with activated LED light show

GENERAL OPERATIONS

Connect to external adapter or computer USB port
Connect micro USB plug of USB cable to main unit micro USB jack and plug the other to computer USB output port or external
adapter output port.
Charging Battery
1. Charging the built-in battery by connecting to USB power for 10-12 hours prior to first use.
2. When the built-in battery is being charged, the charging indicator light red.
3. If the charging indicator turn off when the built-in battery is fully charged.
4. Please charge to CN2 when battery power is low.
Battery Safety Notes:
1. To prolong the life of a rechargeable battery, it is recommended to completely discharge it before fully charging it again.
2. Do not dispose of built-in battery in fire, battery may be explode or leak.
3. Do not open the built-in battery may be explode.
Connecting Bluetooth to your Smartphone I Tablet
1. Slide the Power LED ON.OFF switch to ON to turn on CN2
2. On your smartphone / Tablet, turn on Bluetooth and enable device scanning.
3. When CN2 shows on the Bluetooth scan, select it to connect it to your device.
4. When both devices are successfully connected, you are ready to play music wirelessly from your device.
5. Press the PLAY button of external Bluetooth device to start music playback.
6. Press the NEXT / PREV (BLUETOOTH) of external Bluetooth device to switch between music tracks.
7. Hold the STAND BY button to reconnect other Bluetooth device.
SPECIFICATIONS
DC IN Power
Built-In Battery
SOUND SOURCE INPUT
Total Harmonic Distortion
Signal to Noise Ratio
Master Power Output
Specifications are typical, individual units might vary. They are subject to continuous improvement without notice and without
incurring any obligation.
This product meets the essential requirements of Directive 1999/5/EC.
http://www.idanceaudio.com/documentation/declarationofconformity/
DC 5V , 1A
3.7V , 1200 mAh
Bluetooth, Aux in,
Below 10% at Standard Output
Over 41dB
5W
1
4
5
2
3
Fig.1
ENGLISH
6