De Dietrich AD251 Mode D'emploi page 6

1 Mounting the outside temperature sensor
1.1 Pair the outside temperature sensor with the radio module
Fig.11
1.2 Choosing the position for the outside temperature sensor
Fig.12 Recommended positions for the outside sensor
2
1
Z
1/2 Z
1 Recommended position
2 Possible position
300020521 - v5 - 23012017
Each outside temperature sensor is given a unique identifying number in
the factory, which enables the radio module to recognise it The identifying
number is transmitted to the radio module by the pairing sequence.
MW-1000795-1
It is important to select a position that allows the sensor to measure the
outside conditions correctly and effectively.
1.2.1
Place the outside sensor in a position that covers the following character­
istics:
2
1
H
1/2 H (min. 2,5 m)
1.2.2
Avoid placing the outside sensor in a position with the following character­
istics:
1 Mounting the outside temperature sensor
1. Refer to the assembly instructions for the radio module.
Recommended positions
On a façade of the area to be heated, on the north if possible.
Half way up the wall of the area to be heated.
Under the influence of changes in the weather.
Protected from direct sunlight.
Easy to access.
1/2 H (min. 2,5 m)
H
H Inhabited height controlled by the sensor
Z Inhabited area controlled by the sensor
Positions to be avoided
Masked by part of the building (balcony, roof, etc.).
Close to a disruptive heat source (sun, chimney, ventilation grid, etc.).
en
1
2
MW-8800N001-3
6