Care And Maintenance - LF Garden Treasures A06-188 Mode D'emploi

CARE AND MAINTENANCE

• Periodically clean the filter net to remove dust and dirt.
• A clogged or dirty intake screen will greatly reduce performance. If the pump is used on a dirty
surface, raise it slightly to reduce the amount of debris contacting the intake. If less flow is
desired, adjust the flow control lever on the side of the pump or restrict the discharge flow.
• Regular cleaning of the pump may be necessary depending upon the environment in which it is
operated. Clean the pump when it is visibly soiled or when a drop in performance is detected.
• Before cleaning, always disconnect the pump from the power source.
• Remove all parts from the pump and clean in warm, soapy water.
• Disassemble the pump housing and remove the impeller housing to expose the impeller
assembly. Remove the impeller assembly by gently pulling on the impeller blades. Use a soft
cloth or brush to clean the impeller assembly and the inside of the impeller housing.
TROUBLESHOOTING
PROBLEM
Pump does not
pump water.
The pump fails
to operate.
The performance
of the pump is not
satisfactory.
POSSIBLE CAUSE
1. No power.
2. Reservoir is not full.
3. Fountain reservoir is too dirty.
4. Dirt stuck on pump water intake.
5. Pump impeller is not moving.
6. Pump is not assembled correctly.
7. There is air in the pump and tube.
1. No power.
2. Dirt stuck on the pump.
1. The water does not flow evenly.
2. Dirt stuck on the pump impeller.
CORRECTIVE ACTION
1. Make sure the power cord is
properly connected.
2. Refill by pouring water into
reservoir.
3. Make sure reservoir has no
dirt or other impurities.
4. Make sure the pump's water
intake is not obstructed and
clean properly.
5. Slowly turn the impeller to see
if it is broken or jammed.
Remove any debris.
6. Disconnect the power supply
and check pump assembly.
7. Pull the cord out of the electrical
outlet several times to clear the
pump and tube of air.
1. Check to make sure the power
cord is plugged in and the pump
is getting power.
2. Make sure the pump outlet
and any tubing, fountain, etc.,
is not kinked or obstructed.
1. Make sure the pump is
completely submerged in water.
Adjust flow control.
2. Make sure the impeller and
the housing are clean.
Lowes.com/gardentreasures
6