Audizio Metz Compact Stereo Guide De Démarrage Rapide page 2

When you first connect the unit to the mains socket, display will show the "00:00:00". If you can receive a DAB+ signal in your
location, the unit will synchronize to the current local time. After approximate one minute, it will switch to STAND BY mode.
•
Press the STANDBY on the unit or on the remote control to switch the unit to ON mode.
•
Press the STANDBY on the unit or on the remote control to switch the unit back to STANDBY mode.
•
Disconnect the mains plug from the mains socket if you want to switch the unit off completely.
Note:
1. If the digital radio is not used for 15 minutes, it will automatically enter into standby mode.
2. AUX mode is used for more than 4 hours, the unit will switch to standby mode.
15 minutes before entering standby mode. you will be notified with "AUTO-OFF" flashing on the display. To extend the AUX
mode you can press RANDOM button."
Note: Do you need the full manual? You can download the full manual at www.audizio.com
When the radio is connected to the power supply for the first time, the DAB+ mode will be switched on automatically. The
radio will automatically scan for suitable stations.
When station search is complete, you can use the [
displayed alphabetically. To select a station, press the [ENTER] key.
Full Scan
The "Full Scan" searches all DAB+ and Band III channels. After searching for a channel, the found channels are listed
alphabetically and the first channel is played back.
1. To activate the scan, press the [SCAN] button until the display shows
2. All found stations are automatically saved. Use the [
button on the remote control to select the station.
Switch from DAB+ mode to FM mode by pressing the [DAB/FM] button and selecting FM or by pressing the [SOURCE] button
on the remote control. The display will show the frequency.
Automatic station search
Press the [SCAN] button on the remote control or [PLAY/PAUSE/SCAN] button on the radio to start the automatic station
search. When a station is found, the scan stops automatically.
Manual station search
Press the [PREV/NEXT] buttons to manually select a station.
You can store up to 20 stations, 10 stations in DAB+ mode and 10 stations in FM mode.
1. Set the desired station.
2. Press the [MEMORY] button for about 3 seconds.
3. Use [TUNE] buttons to select the number where you want to store the station and press [ENTER] button to confirm.
4. Confirmation appears on the display.
5. Once a station has been stored, you can recall the station by pressing the "Memory" button.
6. Use the [TUNE] buttons to scroll through the preset stations and press the [ENTER] button to select the desired station.
1. Set your radio to DAB+ mode.
2. Open the CD tray using the eject button on the remote control or on your radio.
3. Press and hold the [STOP] button until the following message appears on the display.
4. After the radio is reset, the DAB+ mode will be selected automatically.
Note: Please note that all programs will be deleted after the reset.
] or [ ]-button to tune in the individual stations. The stations are
] or [ ]-button to find the desired station and press the [ENTER]