Publicité
20 von 43
Weighing-stand installation instructions WI811-30, WI814-25, WI818-25
Reason: The stand is used to weigh the load in the washing machine.
Parts included
Quantity Mat. no.
Designation
1
Stand
2
Side panels
1
Rear panel
1
Front panel
15
4.8 x 9.5 screw
5
Serrated washer, A 6.4
1
Raised-head screw, CEM 6 x 12
1
Weighing electronics
1
Foil
0.66
Terostat profile seal
1
Wiring harness N1-1_ST22, N1-18_ST7
4
Cable holder with expansion anchor
6
Cable ties, 200 x 4.8
4
Bracket
8
M6x25 bolt
12
Washer, B 6.4
4
M6 hex nut
1
Floor fastening accessory pack
1
Concertina hose
2
Hose clip
1
Plate ring
1
Wiring diagram
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work.
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A
Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A
All appropriate safety regulations must be taken into account.
A
Read the technical service documentation (TSD) before starting service work.
Risk of cuts
CAUTION
Components are sharp.
Risk of cuts.
A
Protective gloves should be worn and the edge protection, mat. no. 05057680, should be used.
Weighing stand WI811-30, WI814-25, WI818-25 installation
A
Secure the stand to the floor with the fittings supplied or with other suitable fittings. Use the spacers (1) to align the
stand; see Fig. 1.
21.12.2017
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 10412321
Publicité
