Publicité
Les langues disponibles
Les langues disponibles
HV-112906
PARTS DESCRIPTION
1. Main unit (battery)
2. Dust cup
3. Extension tube
4. Floor brush
5. Long crevice nozzle
6. 2 in 1 crevice nozzle
7. Speed button
8. Handle
9. Dust cup release button
10. Accessory release button
11. Suction hole opening
12. Locking clip
13. Recharge seat/ wall-mounted bracket
14. Charger
15. Battery release button
16. Battery pilot lights
RECHARGE SEAT CAN BE WALL-MOUNTED:
1.
Measure the distance between the holes situated at the back of the bracket and drill four holes in the wall
with the same distance.
2.
Put the expansion bolts into the holes and then use the screws to fix the bracket onto the wall.
3.
Pay attention to the height of the bracket mounted. It shall be mounted more than 80 cm above the floor.
RECHARGING THE APPLIANCE:
1.
When one pilot light is blinking in the process of operation, the appliance needs to be recharged.
2.
Plug the charger into a suitable wall socket and place the vacuum cleaner onto the recharge seat.
3.
While charging, the pilot light will be blinking to indicate the charger is under working. When the charging
operation is finished, the charger will switch off automatically and 3 pilot lights will be on instead of blinking.
4.
After charging, unplug the charger first, and then press the battery release button to take out the appliance.
Note: Do not let the appliance uncharged for a long time, because the inner accumulators may be damaged.
OPERATION
1. Assemble the battery into the dust cup, make sure they combined firmly. (fig. A)
- 5 -
EN
Publicité
