Temperature Mode; Timer; Max/Min- Function; Switching Off - Ellrona Ergo Touch 3500 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

15.4.3

Temperature Mode

 Press the select button until signal lamp temp lights up to select the temperature
mode. The preset temperature stage "240°C" is shown in the display.
 With the + / - keys, you can change the settings at any time in a range from 60 –
240°C. (Temperature stages: 60, 80, 100, 120, 140, 160, 180, 200, 220, 240 °C).
 Please note that the two functions of level (power) and temperature can be chosen as
alternative. You can either work with the power levels or with the temperature stages.
The most recently selected function is active.
 The temperature is measured by a sensor below the glass ceramic plate, therefore the
displayed temperature can deviate from the temperature in the pot.
Please note
► When you fry with very little fat the temperature in the pot bottom rises very rapidly, for
frying turn to temperature mode. Here, the maximum temperature is 240 ° C.
15.4.4

Timer

Timer Function. Press the select button until signal lamp timer lights up. The display
shows „0". With the +/- keys, you can now select the operating time in 1-minute
intervals (up to max. 180 minutes). Once the time is up, an acoustic signal sounds and
the device automatically goes into standby mode.
The display shows alternately the selected function level (power) / temperature temp
or the timer. The corresponding lamp lights upt.
Please note
► During timer operation, you can change the duration at any time with the +/- keys. With
the memory function of the device, the power stage or temperature settings remain
unchanged here.
15.4.5

Max/Min- function

Press min/max button to switch the powerlevel to maximum or minimum.
15.4.6

Switching Off

 Switch of the device with on/off button.
Please note
► Do not place any empty cookware on the ceramic field. Heating an empty pot or pan
activates the overheating protection and the device turns off.
► Do not operate the device if it is damaged in any way or does not function properly.
► The use of accessories and spare parts not recommended by the manufacturer may
lead to damage on the device and injuries.
► The device turns off automatically after 2 hours if no time is set.
Ellrona Ergo Touch 3500
39

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

62018

Table des Matières