Publicité
ENG Manual SOLA BASIC
Dimensions:
Mounting:
Wall or ceiling - Ra>80Ra - Lifetime: 5 years - LED source: SMD2835 - Input:200V-240V 50/60Hz
1
2
Remove the screws using the
If necessary, remove break-
supplied torx bit and remove
out ports for the wiring.
the cover.
6
5
Align the cover with the
Place the cover in position
available cable outlet.
and tighten the screws.
Installation and maintenance should always be done by qualified personnel.
The light source of this fixture is not replaceable, the luminaire must be replaced at the end of its life.
Damaged devices in original packaging are exchanged under guarantee.
Do not touch the LEDs on the circuit board during maintenance or cleaning. Do not use chemical solutions for the cleaning of this appliance.
The grounding must be correctly connected at all times to prevent safety problems.
Always check whether the correct connection voltage is present.
Used lamps
Always return old or defective LED fixtures to an appropriate collection point in accordance with the applicable regulations regarding
environmental protection. Used lamps can be deposited at a recycling point where they are accepted for free. Proper use of equipment makes
it possible to preserve valuable environmental resources and prevent negative consequences for health and the environment.
Integratech bvba – Groenstraat 48 – BE3270 Scherpenheuvel - Belgium
included accessories
dimensions in mm
Ref.
P
A
B
SO10
10~11W
290
103
SO18
18W
290
103
SO28
28W
350
105
3
Press the security clip of the
led pcb together to open.
Mount the base of the device.
Color rendering Ra>80
LED source SMD2835
Power: 220~240V 50/60Hz
Warranty: 5 years
screw
3 st
plug
3 st
torx screw
3 st
torx bit
1 st
ring
3 st
cable clip
1 st
clip screw
2 st
silicon plug
4 st
200~240Vac
4
Connect the power supply.
1/10/2020
Publicité
