Help And Troubleshooting - Kingston Technology DataTraveler 6000 Mode D'emploi

Help and troubleshooting

Device lockout
The DT6000 includes a security feature that prevents unauthorised access to the data partition
once a maximum number of consecutive failed login attempts (MaxNoA for short) has been
made; the default "out-of-box" configuration has a pre-configured value of 10 (no. of attempts).
The ‘lock-out' counter tracks each failed login and is reset one of two ways: 1) A
successful login prior to reaching MaxNoA or 2) reaching MaxNoA and performing a device
format.*
If an incorrect password is entered, an error
message will appear just below the ‘Hint'
field, indicating a login failure.
See Figure 10.1.
th
If and when a 7 failed attempt is made, you will
see an additional error message indicating you
have 3 attempts left before reaching MaxNoA
(which is set to 10 by default). See .
Figure 10.2
th
After a 10 failed login attempt, the DT6000 will
permanently block the data partition and require
a device format prior to next use. This means
that all data stored on the DT6000 will be lost
and you will need to create a new password.
Figure 10.1 – Login failure
This security measure limits someone (who
does not have your password) from attempting
countless login attempts and gaining access to
your sensitive data.
If you are the owner of the DT6000 and have
forgotten your password, the same security
measures will be enforced, including a device
format.*
For more on this feature, see ‘Forgot
Password' on page 19.
th
Figure 10.2 – 7 Login Failure
*Note: A device format will erase ALL of your data stored on the DT6000's secure partition.
®
Document No. 48000191-001.A00 DataTraveler 6000 Page 18 of 21