Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTION
I. CONTROLS (Figure 7)
1.Speed Control Knob
2. Oscillation button
II. CONTROLS PANEL
1. Turning the knob clockwise to your comfort airflow.
2. "
" OSC button
To activate the Oscillation feature, press the Oscillation
key once. Press the Oscillation key again to turn the
Oscillation feature off. In Oscillation mode, the fan will
rotate slowly back and forth from right to left to direct
the air flow over a broader area.
MAINTENANCE INSTRUCTIONS
The fan requires little maintenance. Do not try to fix it by yourself. Refer it to
qualified service personnel if service is needed.
1. Before cleaning and assembling, do not plug the pins into the socket.
2. To ensure adequate air circulation to the motor. Keep vents at the rear of the
motor housing from dust, fluff and etc. A vacuum cleaner can not be used to
clean these vents before unplug. Do not disassemble the fan, remove fluff.
3. Wipe the exterior parts with a soft cloth.
Do not use any abrasive detergent or solvents to avoid scratching the sufrace.
Do not use of the following as a cleaner: gasoline, thinner, bending.
4. Do not allow water or any other liquid into the motor housing or interior parts.
CLEANING
1. Be sure to unplug the power cord from the outlet before cleaning.
2. Plastic parts should be cleaned with mild soap and damp cloth or sponge.
Thoroughly remove soap film with clean water.
3. Be sure not to get water or other liquid enter the inside of the motors.
4. Dry all parts completely before reassembling and reconnecting to power
source.
1
2
4
Fig.7
Publicité
Table des Matières
