Wamsler DENVER Mode D'emploi page 27

glass, and spread them with the use of kitchen paper tissues. It provides an
invisible film on the valuable surface of the Robax glass. This film helps to keep the
glass clean, and facilitates regular cleaning operations. ROBAX S for slightly
contaminated surfaces – a commercially available glass surface cleaning agent –
may as well be used for the cleaning of the medium or strongly contaminated glass
surfaces of the fireplace. Towards this end, spray small quantities of the agent to
the cold surfaces, spread it, and wash it down with a wet cloth, followed by drying
with a clean, soft cloth. In case there are sticky fuel deposits on these surfaces, first
scale simply them with a ceramic-plate scraper held in flat angle, and then clean
the surfaces as described above.
Cleaning of the soapstone: the soapstone is a natural stone, therefore minor
colour differences may occur; as it is normal, they may not serve as a basis for
quality complaints! To clean the soapstone from dirt and fat with water and soap, as
well as small scratches, use sand paper (grain size 240).
Warning: Under no circumstances you may use sponge, scouring, aggressive
or scratching cleaning agents! If the grate is blocked so that the equipment
cannot serve the intended function, the grate is to be removed for cleaning.
pic. 1
pic. 2
pic. 4
pic. 3
27