Accessories - INTEGRA Metering AMBUS Port 60 Instructions De Montage

M-Bus Specifications
Number of unit loads
Bus quiescent current
Level for Max Load
Level for collision detect
Resistance to short circuit
Overcurrent interruption:
Bus quiescent voltage
Bus voltage space
Transmission speed
Max. network extension
(cable type JYSTY Nx2x0.8)
Max. distance to slave
(cable type JYSTY Nx2x0.8)
M-Bus terminals
M+ M- There are three terminal pairs, so that the designations M+, M- serve to differentiate between the M-Bus lines. The M-Bus is
polarity independent.
Power supply
Supply voltage range AC
Power requirements AC
Supply voltage range DC
Power requirements DC
AMBUS ® Port 60 can be powered with the power supply mentioned in the chapter accessories or with any other power supply available on
the market, that meets the specifications.
Terminals
V+,V- Terminals for power supply
Earthing for balancing the M-bus and for diverting peak voltages (for example if lightning strikes).
Temperatures
Operating temperature
Storage temperature
Housing
Dimensions (mm) HxBxT=78x70x118
Protection type IP20
Material / Colour ABS / RAL 7035
Mounting the Housing
A special fixture is attached to the back of the AMBUS
This fixture can also be removed, turned and mounted to a wall with two screws.

Accessories

AMBUS ® Port 60
DIN rail power supply 24VAC, 18W
Head for optical readout and D-Sub-connector for PC Art. No. 80153 + 80157
6
0...60
0...90 mA
90...110 mA
typ. 30 mA
permanent
130...160 mA (min. 50ms)
36...41 V
24...27 V
300...9'600 Baud
1km (9'600bd)
4km (2'400 bd)
> 1200m
20...30 VAC
15 W
20...45 VDC
15 W
0...55°C
-20...60°C
® Port 60 housing for mounting on a top-hat rail TS35 (DIN EN 50022).
Art. No. 93106
Art. No. 93111
®
AMBUS Port 60