NORTH STATES 8666 Mode D'emploi page 5

PROPER SET-UP CONFIGURATIONS
We recommend that you use your
Superyard only as an enclosure, not
as a barrier.
See Figure 7 at right for proper
configuration.
TO OPEN ENCLOSURE
To disconnect two adjoining panels,
select one of the three joints where a
dark gray carpet foot is facing up, as
shown in FIGURE 8 at right.
Gently press down on panel 1 while
lifting slightly on panel 2. This will
enable you to slide pin "C" free of
cylinder "D" (see figure 6). Then lift
up on panel 1 until opening "A" (see
figure 5) is free of pin "B".
FIGURE 7
INCORRECT
FIGURE 8
PANEL 1
CORRECT
INCORRECT
Dark
Gray
Car pet
Foot
Page 5
PANEL 2