Maintenance; Electrics - Optika M-100FL Manuel D'instructions

5.0 MAINTENANCE

5.1 Always think about
- The following environment is required: Indoor temperature: 0-40°C, Maximum relative humi-
dity: 85 % (not condensing)
- Keep the microscope away from dust and shocks while in use.
- Turn off the light immediately after use.
- Use a soft lens tissue to clean the optics after use.
- Only if needed, use a cloth moistened with water and a mild detergent, rinsing with water
and drying immediately with a lint-free cloth.
- After use, cover the microscope with the included dust-cover, and keep it in a dry and clean
place.
5.2 Do not!
- Wipe the surface of any optical items with your hands. Fingerprints can damage the optics.
- Use solvents, neither on the microscope, nor on the optics.
- Disassemble objective or eyepieces to attempt to clean them.
- Mishandle or impose unnecessary force on the microscope.
- Clean the unit with volatile solvents or abrasive cleaners.
- Attempt to service the microscope yourself.
5.3 How to change the lamp
Before changing the lamp, you must switch it off, pull the plug out of the electrical socket.
To avoid being burnt, wait until the lamp has cooled down. Unscrew the condensing lens
above the lamp. Then remove the old lamp and replace it with a new one. Replace the con-
densing lens.
5.4 If you need to send the microscope to Optika for maintenance, please use the original
packaging.

6.0 ELECTRICS

Universal Power: 230 V, 50/60 Hz
Lamp: Halogen bulb with dichroic mirror (for M-100FL)
Fuse:
T1A
Page 5