Hardware Set - Up - Velleman PCSU200 Instructions En Bref

H
ARDWARE
(C
LOSE ALL PROGRAMS BEFORE CONTINUING
USB driver install:
• Connect your PCSU200 unit to a free USB port
• Follow the on screen driver installation procedure.
• If Windows asks for Windows Update, select "not at this time"
• Install the driver from a specifi c location, then browse your drive and select the folder "PCSU200Driver".
(press "next")
• If Windows indicate "has not passed Windows logo testing..." select "Continue Anyway".
• After fi nishing, you can check the driver installation in the Device Manager list.
• It is possible that the PC asks to "restart" for proper installation
Starting the software :
Locate the Pc-Lab200 software shortcuts (programs.. Pc-Lab200 ...)
Click the icon to start the main program. "loading, please wait" should appear. Then the channel indicator
LEDs must go ON. (*)
The main program automatically launches the Oscilloscope and generator screen, which is shown on the next
pages. Should you receive an error (ex. If no unit is detected), disconnect and reconnect the USB cable and
try again or, if you want to access the demo mode (no unit is needed) :
- Click the Options
Note:
• At fi rst time power-up, the oscilloscope will calibrate itself automatically.
• The actual screens can differ from the one shown in this manual.
6
S -
ET UP
menu, and select 'Hardware Setup'
)
> demo mode