Airmax HP Serie Mode D'emploi page 6

2. System Installation - Continued
STEP SIX: Connect Weighted Airline for Diffusers
STEP SEVEN: Connect ProAir™ Diffusers
STEP EIGHT: Start the Aeration System
STEP NINE: Install the ProAir™ Diffusers
6
Unroll the EasySet™ weighted airline and remove any kinks or twists. Join enough
sections of weighted airline, using 3/8" or 5/8" connector kits, so that the airline can
rest on the bottom of the pond, from the pond's edge out to the planned location for
each diffuser. For option B installations, connect the weighted airline to the direct
burial airline or Remote Manifold Kit at the pond's edge.
Note: Diffusers should be placed equally apart or in areas of low water movement for
optimum performance. If you need help choosing the correct location for your diffusers,
please contact Airmax or your local dealer.
®
See the ProAir™ Diffuser Manual for assembling and connecting the diffusers.
SW20HP: Plug the compressor and cooling fan into the power control outlet inside
of the cabinet.
SW40HP: Plug the compressor into the power control outlet inside of the cabinet.
The cooling fan is already hardwired. Ensure the power switch is in the"ON" position.
Plug the power control outlet into a GFCI power outlet.
Installing Diffusers from a Boat/Raft:
Have one person on shore guiding the airline as a second person uses a boat or raft,
extend the airline out to the area of the pond that the diffuser will be located. Gently
release the diffuser into the water. Repeat until all diffusers are in position.
Installing Diffusers from Shore:
For smaller ponds you may choose to install the diffusers from shore. Have one
person guide the airline while another walks around the pond with the diffuser. Then
thread nylon rope through the diffuser manifold. Use the nylon rope and airline to
gently guide the diffuser into place. Once set, release one side of the nylon rope and
pull to shore. Repeat until all diffusers are in position.
ENGLISH