WEBTEC HPM6000 Guide Rapide page 12

Quick start – measurements using sensors with sensor-ID functionality
Connecting analogue sensors (for measurement chains with IP54 protection)
If you have purchased your measuring instrument with an input module, connect the ana-
logue sensors (with sensor detection capabilities) to the analogue inputs IN1 to IN3 as
shown in the illustration. Similarly, connect analogue sensors to the analogue inputs IN6
– IN8 on the second optional input module.
IN 1
A Analogue ports
IN1 – IN3
12
NOTICE
The plastic caps protect against dust and splashed water. Be sure that the caps
are always covering any unused ports.
IN 2 IN 3 IN 6
A
B Analogue ports
IN6 – IN8
IN 7 IN 8
B
C Connection cable
D Analogue sensor
C
D