Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 2 black BHc Ø6x15 screws big head
- 3 Ø6 rubber washers
- 1 black BHc Ø5x20 screw big head
Fitting
- Dismount the original chain guard and hoses fixing bracket.
- Fit the Ermax rear hugger thanks to the 6x15 screws at the chain guard side and the 5x20 screw at the
holes side (screws and washers). Keep the original holes support.
- Make sure the rear hugger is well centered over the tire before the final tightening.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* A few tyres, faithful to ETRTO standards, may be in fact bigger and higher than dimensions engraved on the tyre (until + 10 mm). They may be not compatible with undertrays and rear huggers which we made with original
tyres and whose dimensions correspond to these ones engraved on tyre.
* Harden the rear shock absorber while drivings with load or on dented roads.
FITTING INSTRUCTIONS
ADAPTABLE ON DL 650 V STROM 2012 → ∞
« CAUTION »
ERMAX REAR HUGGER
Durée de montage estimée : 30 min
Publicité
