Filling / Emptying The Water Tank - SPORTSTECH WRX700 Manuel

FILLING / EMPTYING THE WATER TANK

1. Remove the cap from the top of the tank.
2. Use the intelligent wireless water pump to fill (clear water is recommended). The metal pipe is
aligned with the opening of the water tank. The plastic hose is held to the water source. Press the
button on the pump for automatic filling.
3. The amount of water should not exceed the specified level indicator. (No liability is accepted for
water damage, device malfunctions, etc. in the event of incorrect filling procedure).
4. Make sure that the cap is properly positioned and fully closes the water tank.
1. The emptying takes place in reverse via the 'fill' opening of the water tank.
2. To do this, the plastic hose / suction nozzle is held in the water tank. The metal pipe is aligned with
a collecting container or a suitable drain outlet. Press the button on the pump for automatic drainage.
(Make sure that the water is led into a sufficiently large collecting container or drain to prevent
overflowing!
39