Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 2 screws BHC 6x35 steel
- 2 screws BHC 6x30 steel
- 2 plastic spacers 6x10
- 2 rubber spacers 6x5
- 4 washers nylon Ø6
Fitting instructions
- Unscrew the 4 original screews.
- Place the Ermax screen on the original screen with the screws 6x35 and the plastic spacers 6x10 on the top,
and the screws 6x30 and the rubber spacers 6x5 on the bottom. Spacers are to be placed between the screen and
the bike, and washers under the heads of screws.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Screens damaged by an inadequat washing are not guaranteed (abrasive, corrosive ... products, solvent, thinner, benzine ...). Wash immediately brake or battery fluid which may flow on accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
FITTING INSTRUCTIONS
ADAPTABLE ON MT-10 2016 → ∞
« CAUTION »
EN
Date updating : 05/05/17
ERMAX SCREEN
Estimated fitting time : 10 mn
Publicité
