Hama Vent Mode D'emploi page 4

4. Installation
Note
• Before installing the holder, check the installation options in your vehicle. If in doubt, check the
vehicle's instruction manual or contact the vehicle manufacturer.
• Check the load-bearing capacity of the slats before inserting a device into the holder. This
installation version is only recommended for devices < 300 g.
• Never apply force when using the product or during installation.
• Slide the grating clamp carefully onto the open slats of the grating until it engages.
• To remove it, carefully pull the holder out of the grating.
5. Inserting / removing devices
• Place the back of your Apple smartphone on the in-car holder. It attaches automatically thanks to
the integrated magnets.
Note - devices
Please note that this product is only suitable for Apple smartphones of the latest generation (12).
6. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from
improper installation/mounting, improper use of the product or from failure to observe the operating
instructions and/or safety notes.
5