Table des Matières
Publicité
ASSEMBLY INSTRUCTIONS
STEP 5.
Place the tank housing on the stand.
STEP 6.
Insert the gas hose through the post (see
photo) and attach the
burner
housing to
the post by 4 pcs screws.
Note: Make sure that the Hose is hanging
freely in the Tank Housing.
STEP 7.
Connect regulator to the end of the hose
that you inserted through the pipe from the
main bumer head in step 6 (as shown).
STEP 8.
Check whether the connection of vertical
post and
burner
are assembled according
to instructions, and all bolts and nuts are
tightened.
Incline the heater first for easy assembly,
Secure the threaded ends studs on flame
screen cap with 3 threaded ends studs.
Using Screw set E. Screw the three
Hex-posts into the holes in the top of
the emitter head. Put one washer on
each Hex-post. Put the reflector on
the three posts and fasten using the
remaining washers with wing nuts.
11
Publicité
Table des Matières
