Weighting - Nahita 5161-LED Serie Mode D'emploi


Remove all loads from the pan, press function key TARE to clear the readings to 0g,
0.0g.

Press and hold function key CAL for 3 seconds, release function key CAL when
"---CAL---" is shown in the display, a figure of standard weight will flash in the display. Put a
standard weight on the pan accordingly, standby state "------" will be shown in the display for
a few seconds before the standard weight figure is shown in the display. R emove the
weight, "------" standby state will remain for a few seconds before the balance enter stable
weighing mode, showing 0g, 0.0g.

It is recommended to make the operation twice to achieve the best calibration result.

5. WEIGHTING

When the balance is warmed up and calibrated, 0g, 0.0g is shown in the display indicating
weighting mode. Put the object on the pan, when stable, the weight of the object is shown in
the display.
Taring
When a container is put on the pan, its weight is shown in the display. Press function key
TARE, 0g, 0.0g will be shown in the display, indicating the weight of the container is
deducted. Put the object into the container, when stable, the figure shown in the display is
the weight of the object.
Piece counting
Remove all loads from the pan, press function key TARE to clear the readings in the
display, press function key COU to enter counting mode. Figure 10 (default sampling
quantity) will be shown in the display, weighting unit changes from g to pcs. Put 10
samples on the pan, press function key COU, the balance will show "-----" before it shows
10 pcs in the display. The balance enters counting mode.
Notice: In counting mode, the weight of the sample objects should be even, the weight of
the individual sample should not be less than the readability of the balance.
Return to weighting mode
Press function key COU to return to weighting mode.
Unit conversion
Press function key UNIT to change weighing unit kg/lb/g, default weighting unit is set to g.
Overload
The weight of the object cannot exceed the rated maximum capacity of the balance, when
exceeding, "-------" will be shown in the display. Remove the object immediately from the pan
so as to prevent damages to the balance.
15