Installation Height - Fairland IPHC 25 Notice D'installation Et Conseils D'utilisation

14.1.7

Installation height

If the machine is wall mounted, the intrinsic strength of the wall and the mounting must be sized, with a
safety margin, to bear the weight of the machine when filled with water. Take exposure to prevailing winds
into consideration. Mounting brackets must be treated against corrosion.
Make sure the filtration pump can overcome the height difference between the filtration pump and the heat
pump. Take any necessary steps (increase pump power, additional pump, etc.).
14.2
Support
The heat pump must be attached by its feet to a solid, stable and horizontal base (stainless steel M
10screws. A sloped position could interfere with the flow of condensates.
In the interest of noise abatement, the machine and pipes connected to it must be installed in such a way
that they do not vibrate while running.
14.3
Handling
Never lift the machine by its hydraulic unions.
Do not store the machine lying on its side. If the machine was laid on its side, put it upright after storage,
and leave it stand like this, switched off, for at least 48 hours.
14.4
Connection to the hydraulic circuit
The heat pump must be mounted on a filtration circuit by-pass, downstream from the sand filter, and
upstream from the injection of any treatment chemicals (the titanium condenser is resistant to dilute pool
chemicals, but is not guaranteed against exposure to high concentrations of pool chemicals).
The bypass loop must be fitted with three valves, one on the bypass intake, one on the bypass outlet
(isolation valves) and one between the two tapping points (valve to control the flow rate through the heat
pump).
To limit heat loss from the pipes, bury them underground (at a depth of 50 to 80 cm depending on the
region) or lag the pipes. In any case, minimize the amount of uninsulated pipe exposed to the air.
21/28
2016/11 - Code : 33315