Publicité
Les langues disponibles
Les langues disponibles
Step 3:
Proceed to core or drill a hole at the predetermined height. Figure 1 provides dimensions for the re-
quired cut-out.
Step 4:
Prebend the intake and exhaust
venting, do NOT exceed 90
degrees. After the elbow, stretch
the venting to the desired verti-
cal height.
Step 5:
Attach the venting to the wall
terminal using the supplied hose
clamps. Note the exhaust inlet
is the inlet with the reducer as
seen in the Figure 2.
Figure 2: Top View
Step 9 [E30 & E33 installations only]:
Set the adjustable plate located in the firebox baffle to the most open position using a Torx T20
screwdriver. Refer to the Owner's Manual for further information.
Initial Installation
QUALIFIED INSTALLERS ONLY
NOTE: Holes are
orientated at a 40
degree angle
Roughly
5-3/4"
Roughly 5"
Exhaust
Intake
THIS DRAWING IS THE PROPERTY OF SHERWOOD INDUSTRIES LTD. AND MAY NOT BE COPIED, REPRODUCED, OR OTHERWISE DISCLOSED W
Figure 1: Cut-outs
Step 6:
Feed the stretched venting into the exterior hole and
down the chimney. This kit can be used from 3'-7' (see
Table 1), trim any excess vent as needed. Mount the
wall terminal to the chimney with screws. Seal as per lo-
cal codes and regulations.
Step 7:
UNLESS OTHERWISE SPECIFIED
ALL DIMENSIONS IN INCHES
Ensure that the vent length is correct, and the venting is
General
Hole Size
not crimped or overstretched.
+/- .005
+/- .001
Step 8:
DIMENSIONS APPLY AFTER PLATING OR
Attach the venting to the top of the fireplace using 3
THREADS EXTERNAL CL 2A INTERNAL CL 2B
screws per vent. Making sure the intake is on the intake
collar. The intake collar is on the left side of the fireplace
for the Q1 and is indicated on the flue collar of the E
series units by the "IN".
Roughly 6-3/4"
Exterior View
3" Dia.
Figure 1: Cut-out size
MATERIAL
TOLERANCE
Angles
Hole Pos.
+/- .002
+/- .5
DRAWN BY
CHECKED BY
HEAT TREATMENT
APPROVAL
4" Dia.
Sh
Part Descrip
10/4/2018
HEAT TREATM
SCALE- NOT
Publicité
