Disarm; Arm; Monitor; Store Alarm Phone Numbers - Smanos X300 Manuel D'utilisation

Disarm

This is to disarm the system.
1. Send "0"
Send the SMS "0" to the phone number of the control panel.
2. Disarm the system
After the control panel receives the SMS, the status LED flashes quickly and then the
mode LED is off. The system is disarmed. The control panel replies SMS to your smart
phone with the content: System disarmed.
System disarmed.

Arm

This is to arm the system.
1. Send "1"
Send the SMS "1" to the phone number of the control panel.
2. Arm the system
After the control panel receives the SMS, the status LED flashes quickly and then the
mode LED is on. The system is armed. The control panel replies SMS to your smart
phone with the content: System armed.
System armed.
31
0
1

Monitor

This is to monitor the site remotely by call-back from the control panel.
1. Send "2"
Send the SMS "2" to the phone number of the control panel.
2. Monitor the site
After the control panel receives the SMS, the status LED flashes quickly. The control
panel calls your phone number. Then, you can answer the call and monitor (listen in)
the site.

Store alarm phone numbers

You can store 5 alarm phone numbers by SMS. When an alarm is triggered, the control
panel will send SMS to the stored alarm phone numbers in turn, and then call these
numbers in turn. After the control panel receives an alarm signal, it takes about 15
seconds to send the first SMS. (The time may differ from network signal strength.)
1. Send "3"
Send the SMS "3" to the phone number of the control panel.
2
3
32
EN