HEATIT HIP 24-12B Manuel page 5

GENERAL INSTALLATION INSTRUCTIONS
8. Reopen the supply valve to the hot water heater and allow the water to run until all the air has been purged from
the piping.
9. Close faucet inside the house.
10. Plug the line cord of the pump into a 115V outlet. Be sure to route the power cord so that it does not touch the
exhaust vent piping of a gas or oil-fired hot water heater.
Key points of installation: remember to open the valve of cold
water pipe/hot water pipe/return pipe after installation.
DO NOT Mount Motor Shaft in Vertical Position
Commissioning
Panel description
Function description
Mold name
Smart constant
temperature mode
Energy-saving constant
temperature mode
Manual mode
Function name
Mode switch
Pump speed switch
Antifreeze protection
When turned on, the
temperature throughout a day.
When turned on, the icon lights green, and the pump operates at an energy-saving
constant temperature state throughout a day.HEATIT Smart pump can decrease the
temperature setting point automatically if you didn't use the hot water for some time.
When pressing the icon briefly in any state, the pump will stop after reaching the set
time or target temperature.
Smart constant temperature mode (orange light), energy-saving constant temperature
mode (green light), Manual mode (no light).
The product is divided into three gears. When running, the gear is indicated by the
rotating speed of the light bar. The faster the rotating speed is, the higher the gear is.
When the water temperature of the pipeline is lower than 5℃ for 30s, the electric pump
will operate until the water temperature meets 10C. If the water temperature can't meet
10C, a buzzer will sound to give an alarm.
Speed
Mode Set
Mold description
icon lights orange, and the pump operates at constant
Function description
5
HEATITCABLE.COM