Gardeo GFBHT65-7T Manuel page 26

Do not attempt to split green
logs. Dry, seasoned logs will be
split much more easily, and not
be jammed as frequently as
green wood.
3. Before operation, applying a thin coat of
grease to the surfaces of the ram will lengthen
the durability of the ram.
4.
Open the Air Bleed. Loosen the oil tank cover
a few turns whenever the splitter being used.
Retighten this cover when you finish.
Grease
26
5. Turn the motor on, the wedge ram should
rise to the highest position automatically. If
the wedge ram is already at the highest
position when the motor starts, grip both
control levers and lower them, the wedge
ram should start to move downward.
6.
While operating under extremely low
temperature, keep the log splitter running
under no load for 15 minutes to preheat the
hydraulic oil.
7. Before initial operation, check to be sure the
two-handed operation is properly functioned
by following steps:
Lower both control levers, splitting wedge
(1)
lowers to approx 5cm above the highest
table position.
Release either of the levers, splitting wedge
(2)
should remain in the original position.
Release both levers, the ram should rise
(3)
to the highest position automatically.
8.
To set wedge ram stroke, take the following
steps:
(1) Move splitting wedge to the desired position.
The upper position of the ram wedge travel
should be about 3~5cm over the logs to be
split.
(2) Release a control lever or switch off the
motor.
(3) Release the Setscrew (A) with L key.Raise
Adjusting Rod (B) until Adjusting Rod (B)
is started to be stopped by the spring inside.
Tighten the Setscrew (A).
(4)
Release both control levers and start motor.
Check the upper position of the splitting
(5)
wedge.