Care And Maintenance - Silent Beacon EASE Manuel

Pressing either Alert Buttons until the Silent Beacon

vibrates, then releasing will activate the Alert Mode.
While in Alert Mode, the Silent Beacon will blink red

until the phone call has been connected. It will then
be solid red until the call has been ended.
In Alert Mode, you may hold down one button on

the Silent Beacon for approximately one second to
silence the Speaker and LEDs. To undo this, simply
hold down one Alert Button for another one second.
Pressing and holding both Alert Buttons for 20

seconds will reset the alert mode.*
Pressing and holding both Alert Buttons for 30

seconds will reset the device. You will have to fully
reconnect the Silent Beacon again by following
steps 4 and 5.*

Care and Maintenance

*Should only be used if absolutely necessary.
E