Publicité
KEY-OVERRIDE-ALL
Copyright © 2009, FORTIN AUTO RADIO INC
PROGRAM. 1
1
Connector 1 (Black):
Determin the type of installation:
1.A
-
INSTALLATION WITH
-
INSTALLATION WITHOUT DATA-LINK (See P.1, Plan 2)
Connector 2 (White):
1.B
Make the connections associated with the
vehicle in the VEHICLE FIT GUIDE (P.2-3)
PROGRAMMATION
Vehicle equipped with SMART KEY
10'
2
3
If the LED is flashing at this point the module is already programmed and can't be
programmed again. (To prevent malicious use this module can be programmed in
only one vehicle.)
KEY#1
4
KEY#1
5
TECHNICAL SUPPORT / INFORMATION
Neither the manufacturer or distributor of this module is
responsible of damages of any kind indirectly or directly
caused by this module, except for the replacement of this
module in case of manufacturing defects. This module must
be install by qualified technician. This instruction guide may
V
change without notice. isit www.ifar.ca to get latest version.
ALL RIGHTS RESERVED
Make the connections to the vehicle:
DATA-LINK
(See P.1, Plan 1)
Remove all keys from key remote cards.
Keep the card away from the vehicle (10
feet/3 meters minimum) to proceed with the
programming procedure.
Keep programming button pressed while
inserting
connector 1
.
Insert
connector 2
.
Release the programming button when the
LED turns ON.
Insert the first functional key into
the ignition barrel and turn the
ignition ON.
When the security light turns OFF,
turn the key to the OFF position and
remove the first key from the
barrel.
FORD / JAGUAR / MAZDA / LINCOLN / MERCURY
SEE VEHICLE FIT GUIDE (P.2) TO IDENTIFY THE SYMBOL.
For the vehicles identif
ro nd
u
symbol
(1 key required)
KEY#1
6
Insert the first functional
key into the ignition barrel
again and turn the ignition
ON.
KEY#1
7
When
the
security light turns OFF,
turn the key to the
position
first key from the barrel.
8.a
For MANUAL
Transmission:
Press and release the
programming button.
The LED will flash 1 time.
8.b
With a jumper wire, apply
power (12v) to the vehicles
ignition wire until the
board security light turns
OFF
. Remove the jumper.
9
Technical support:
TEL: 514-255-HELP (4357)
1-877-336-7797
Web: www.ifar.ca
INSTALLATION GUIDE
Made in Canada - Rev. ZA - 06 / 11 / 2009
W e b
s i t e :
h t t p : / / w w w . i f a r . c a
For the vehicles identified with
ied
with
square symbol
(2 key required)
6
Insert the second functional
key into the ignition barrel and
turn the ignition ON.
7
dash
board
W h e n
security light turns OFF,
OFF
the key to the
and remove the
and remove the second key
from the barrel.
You have 10 seconds to complete one
of the following procedures
Ignition
Activate the remote starter.
12V
dash
If the LED flashes 10 times, the
module is programmed.
If the LED turns ON, repeat from step 1.
You have 5 seconds
to complete the
following procedure
KEY 2
KEY 2
#
#
KEY 2
KEY 2
#
#
t h e
d a s h
b o a r d
turn
OFF position
For
AUTOMATIC
Transmission:
P.11
Publicité
