R2 RACING WHEEL PRO Mode D'emploi page 9

Programming
Button Layout
Programmable keys
Notes: Please turn the parking brake OFF before programming.
Key programming
Programming keys (Playstation, XBox, PC & Switch - groups):
/2/A/B, L1/5/LB/L, L2/7/LT/ZL, R1/6/RB/R, R2/8/RT/ZR
The defined programming keys include: left shift rocker, right shift rocker, handbrake switch,
clutch-throttle and brake pedals.
Program design configuration
• Press the „PROG" button once, then the red LED will flash rapidly.
• Press the defined programming key once, then the red LED flashes slowly.
• Press the programming key once, then the red LED is on.
• Programming is completed.
16
/1/X/Y, /3/B/A, /4/Y/ X,
Delete programming
• Press the „PROG" key once, then the red LED flashes quickly.
• Press the defined programming key once, then the red LED flashes slowly.
• Press the defined programming key again, then the red LED lights up.
• The programming step is deleted.
Delete all programming
• Press the „PROG" key once, then the red LED flashes quickly.
• Press and hold the „OPTIONS/10/MENU/+(depending on the system)" keys for 4 seconds
until the red LED lights up.
• All defined key functions are deleted and the sensitivity is reset to the high level.
Exit programming
• Press the „PROG" key once, then the red LED flashes quickly.
• Press the „PROG" key again to exit the programming sequence.
• The previous data is retained.
• Press the „PROG" button once, then the red LED flashes quickly; if no further action is taken,
the programming process is automatically terminated after 10 seconds.
Sensitivity
Lower level
• Press the „PROG" button once, then the red LED will flash rapidly.
• Press the lower direction button to set the sensitivity to the Low level.
• The red LED lights up and the setting is successful.
• When the red LED lights up, the setting is successful.
Medium level
• Press the „PROG" button once, then the red LED will flash rapidly.
• Press the left or right direction key to set the sensitivity to the middle level. When the red LED lights up,
the setting is successful.
High level
• Press the „PROG" key once, then the red LED flashes quickly.
• Press the upper of the two direction keys to set the sensitivity to the high level.
• When the red LED lights up, the setting is successful.
17