N-Gear MOVE WASH LIGHT 7 Manuel D'utilisation page 3

Features
Multi Colors
Color Strobe
Electronic Dimming 0-100%
Built in Microphone
DMX-512 Control
Auto/ Master & Slave synchronization
Multi-channel mode
Set up
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
Power Supply : Before plugging your unit in, be sure the source voltage in your area matches the
required voltage for your. The Light is available in a 110v to 250v version. Because line voltage may
vary form venue to venue, you should be sure your unit voltage matches the wall outlet voltage
before attempting to operate you fixture.
Fixture linking
You will need a serial data link to run light show of one or more fixtures using a DMX-512 controller
or to run synchronized on two or more fixtures set to a master/slave operating mode. The combined
number of channels required by all the fixtures on a serial data link determines the number of
fixtures the data link can 511 port.
Maximum recommended serial data link distance:500 meters (1640ft) .
Maximum recommended number of fixtures on a serial data link:32 fixture/
Data cabling
To link fixtures you must obtain data cables. If you choose to create your own cable please use data-
grade cables that can carry a high quality signal and are less prone to electromagnetic interference.