Setting Up The Audio Options; Pcm Down Sampling - Samsung DVD-P250K Mode D'emploi

C S
H A N G I N G E T U P M E N U

Setting Up the Audio Options

Audio Options allows you to setup the audio device and sound status settings
depending on the audio system in use.
1
With the unit in Stop
mode, press the MENU
button.
2
Press the $/❷ buttons to
select Setup, then press
the ❿ or ENTER button.
Setup
3
Press the $/❷ buttons to
select Audio Setup, then
press the ❿ or ENTER
button.
Setup
4
Press the $/❷ buttons to Dolby Digital Out Dolby Digital Out
select the desired item,
then press the ❿ or
ENTER button.
ENG-48
To make the setup menu disappear, press
the MENU button.
C S
H A N G I N G E T U P M E N U
Dolby Digital Out
- PCM : Converts to PCM(2CH) audio.
- Bitstream : Outputs Dolby Digital via the digital output. Select Bitstream when connecting to a
Dolby Digital Decoder.
MPEG-2 Digital Out
- PCM : Converts to PCM(2CH) audio.
- Bitstream : Converts to MPEG-2 Digital Bitstream (5.1CH or 8CH). Select Bitstream when using
the Digital Audio Output.
DTS
Select On when connecting to a DTS Decoder.
- Off : Doesn't output digital signal.
- On : Outputs DTS Bitstream via digital output.
Note
• There is no analog audio output when you play a DTS sound disc.
Dynamic Compression
- On : To select dynamic compression.
- Off : To select the standard range.

PCM Down Sampling

- On : Select this when the Amplifier connected to the player is not 96KHz compatible. In this
case, the 96KHz signals will be down converted to 48KHZ.
- Off : Select this when the Amplifier connected to the player is 96KHz compatible. In this case,
all signals will be output without any changes.
Note
Even when PCM Down sampling is Off
• Some discs will only output down sampled audio through the digital outputs.
Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are
trademarks of Dolby Laboratories.
"DTS" and "DTS Digital Out" are trademarks of Digital Theater Systems, Inc.
ENG-49