Maintenance; Maintenance Schedule - Senix GTC4QL-L Manuel De L'opérateur

CLEANING AND CARE
WARNING:
To avoid serious personal injury, always stop the engine
and allow it to cool before cleaning or maintaining the
unit. Never perform cleaning or maintenance while
the unit is running. Disconnect the spark plug wire to
prevent the unit from starting accidentally..
WARNING:
Wear protective clothing and observe all safety
instructions to prevent serious personal injury.
WARNING:
Never use metal-reinforced line, wire, chain or rope.
These can break off and become dangerous projectiles.
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.

MAINTENANCE SCHEDULE

Item
Check engine oil level
Check for loose/lost
fasteners
Check for damage
Verify function of control
elements
Check fuel level
Check for fuel/oil leaks
Check cutting line
Engine oil replacement
Clean air cleaner
Check spark plug
REMARKS
• The maintenance interval is only a recommendation
for machines in ordinary operating condition.
• If there are any abnormal signs from the machine,
please do the proper inspection and maintenance
immediately.
• The tightening torque should follow the general screw
specification of different size, class and material.
• If anything is unclear to you, contact our service team
for help.
• All other repairs or maintenance which are not
mentioned here should only be done by our service
team or authorized personnel.
WWW.SENIXTOOLS.COM

MAINTENANCE

Hours of Operation
Every time before use
Every 20 hours
Every 20 hours. Every 10
hours in dusty conditions
Every 20 hours
REPLACE ENGINE OIL
WARNING:
Old engine oil is considered special waste and has
to be disposed according to your local environment
protection regulation. Do not pour the oil into a garbage
can, sewer, soil etc.
The engine oil replacement is easier if engine is warm
(NOT HOT!).
1. Open the oil tank cap and drain the old oil to an
approved container.
2. Return the engine to an upright position and refill with
lubricant following the instructions in the ADDING/
CHECKING ENGINE OIL section in this manual.
3. Clean the oil dropped on the unit if necessary.
CLEAN AIR FILTER
The air filter element should be cleaned to provide the
engine abundant clear air which aids in starting, power,
and life time of the engine.
1. Remove the air filter cover. To remove, press the
green button on the top of the cover with thumb and
gently push up the cover with index finger.
2. Remove the air filter.
3. If only cleaning of the air filter is necessary, take the
air filter pad out and clean it with dry compressed air
until all dust is removed. Wear protective goggles and
mask to protect your health during this procedure.
Reinstall the air filter cover by closing the air filter cover
over the button on the housing, then push the cover
until it locks securely in the place.
NOTE: Make sure the filter is seated properly inside the
cover. Incorrect installation will allow dirt to enter the
engine, causing rapid engine wear.
SPARK PLUG INSPECTION
CAUTION:
Do not remove the spark plug when the engine is hot.
1. Pull off the spark plug cap and clean the dust in the
spark plug area.
2. Remove the spark plug with the provided socket
wrench.
3. Check the ceramic isolation. Replace the spark plug
if damaged.
4. Clean the electrodes (metal tip) to refresh the
surfaces.
5. Reinstall the spark plug or replace it if necessary.
Reinstall the spark plug cap.
MAX
11