ENGLISH
3. Components that could be swapped over from one side to the other in pairs are
listed below:
– adjustable foot with internal thread (used with the lower hinge)
– adjustable foot with bolt (fixed at the bottom)
4. Components that could not be reused temporarily are listed below :
– left fridge door stop
– right fridge door stop
Note :
Ensure the Appliance is unplugged and empty.
Adjust the two leveling feet to their highest position.
We recommend you have someone to assist you.
To take the door off it is necessary to tilt the Appliance backward.
You should rest the Appliance on something solid e.g. a chair just below the top
panel.
Do not lay the Appliance completely flat as this may damage the coolant system.
MAINTENANCE
FRIDGE DEFROSTING
• The fridge defrosting process is carried out
automatically every time the compressor stops.
• The defrost water is automatically routed to the
drain port and into a tray placed on the top
of the compressor to the rear of the appliance
from which it evaporates.
• Make sure the drain port on the fridge at the
rear of the appliance is kept clear.
GB-14
FREEZER DEFROSTING
• Frost will accumulate inside the freezer
depending upon the length of time during
which the door is left open or the amount of
moisture introduced.
• It is essential to ensure that no frost or ice is
allowed to form at places where it will affect
the close fitting of the door seal.
• This might allow air to penetrate the cabinet,
thus encouraging continuous running of the
compressor.
• Thin frost formation is quite soft and can be
removed with a brush or plastic scraper. Do
not use metal or sharp scrapers, mechanical
devices or other means to accelerate the
defrosting process. Remove all dislodged frost
from the cabinet floor.
• For the removal of thin frost it is not necessary
to switch off the appliance.
• For the removal of heavy ice deposits
disconnect the appliance from the mains
supply and empty the contents into cardboard
boxes and wrap in thick blankets or layers of
paper to keep them cold. Defrosting will be
most effective if carried out when the freezer is
ENGLISH
GB-15